Tapcon^® Concrete Screws

Installation Instructions for Tapcon® Concrete Screws

The installation of Tapcon® Concrete Screws can be completed by following the three easy steps described below. Concrete screws can be used in a wide range of applications including electrical boxes, wood headers, plywood, furring strips, and exterior insulation systems. Tapcon® concrete screws are ideal for use with medium duty fastening applications. These screws come in a variety of sizes and styles are easy to install. After installation, Tapcon® screws can be removed without disturbing the base material.

1. With sleeve off and drill bit exposed, drill pilot hole 1/4" deeper than recommended anchor embedment. Snap proper anchor socket onto end of sleeve. Slide drive sleeve over drill bit.

2. Insert head of Tapcon® anchor into hex or phillips socket.

3. Put point of anchor into pre-drilled hole and drive until anchor is fully seated.